Copper braid cb race 0.35mm - 1m

CB Race Copper Braid from Sloting Plus: Clean Contact and Stable Current on Every Lap

Braids are one of those components that make the difference between a car that is well powered to the motor and one that suffers from micro-cuts, stutters, or unexplained power losses. This CB Race copper braid from Sloting Plus combines a thickness of 0.35 mm with 3 mm width and comes in a bag of 1 metre length, enough to renew the braids of several cars or to always keep a good spare on the workbench.

Technical Specifications

• Material: copper
• Thickness: 0.35 mm
• Width: 3 mm
• Length: 1 metre per bag
• Reference: SP104135
• Manufacturer: Sloting Plus

Function and Performance

Braids are responsible for transmitting electrical current from the track rails to the car's motor, passing through the guide. A good conductivity copper material reduces electrical resistance, resulting in a more direct response to the trigger and a more consistent power supply, especially in sections with consecutive curves where the guide operates in extreme positions.

The thickness of 0.35 mm is a reference measurement in preparation: thin enough to sit well in the guide's braid holder and maintain a smooth contact with the rail, without adding unnecessary stiffness that could hinder the lateral movement of the guide.

Installation and Preparation

To install the braids correctly, cut the necessary length adjusting it to the path from the guide to the motor terminals on your chassis. Carefully bend the ends to ensure good electrical contact, without excessively pressing the copper to avoid crushing it. Ensure that the braid runs without tension or sharp bends that could fracture the strands over time.

With 1 metre available, you can cut and adjust calmly until you find the perfect path, and still have leftover material for future revisions.

Common Mistakes

• Too short braids: create mechanical tension in the guide and limit its movement. Always leave a small margin of slack.
• Too long braids: can get caught in moving parts of the chassis or rub against the track surface. Adjust the path properly.
• Poor soldering: is the number one cause of micro-cuts. Ensure that the soldering is clean and the braid is well secured both in the guide and at the motor terminal.
• Not regularly checking the condition of the braids: copper wears out with use. Periodic checks on the workbench prevent surprises during racing.

Frequently Asked Questions

How many cars can I prepare with 1 metre of braid?

It depends on the chassis and the path you take to the motor, but usually with 1 metre you have enough material to renew the braids of between three and five cars comfortably.

Is this braid compatible with any slot guide?

Yes, as it is a roll material that can be cut and adapted, it is compatible with any type of guide and chassis, regardless of the brand or rail system you use.

How often should I change the braids?

There is no fixed rule: it depends on usage, the track, and driving conditions. The most practical approach is to visually check them every few sessions and replace them when signs of wear, crushing, or loss of flexibility appear.

Can I use this braid on both Scalextric/Ninco and Scaleauto/Slot.it tracks?

Yes. As it is an internal component of the car that connects the guide to the motor, its compatibility does not depend on the rail system but on the chassis design. It works for any setup.

Is it necessary to solder the braids or can they be fixed in another way?

Soldering is the most reliable method to ensure stable and durable electrical contact. Other forms of fixing may work temporarily, but in intensive use or competition, soldering is the recommended option.

The Sloting Plus CB Race copper braid (0.35 mm thick, 3 mm wide, 1 metre length) is a precision slot car braids upgrade designed for consistent electrical contact and low resistance power transfer. Ideal for slot car preparation, braid replacement, and competition tuning. Compatible with all slot car chassis and guide systems.