Front Pulley 6mm

6.0 mm Front Pulley with 3D Mount for Sloting Plus Wheels

The 6mm Front Pulley (Ref. SRP018121) from Sloting Plus is a preparation spare part designed for those working with front transmission systems in their slot cars. The mount, manufactured using 3D printing, ensures precise geometry and a clean fit on the corresponding wheel.

Function and Performance

The front pulley acts as a key element in setups with traction or transmission to the front axle. Its diameter of 6.0 mm determines the gear ratio and, therefore, directly influences the car's response on track. Choosing the correct size is part of the fine tuning work that makes a difference in club competition.

• Diameter: 6.0 mm
• Mount manufactured by 3D printing
• Compatible with Sloting Plus wheels
• Contents: 1 unit

Compatibility

This spare part is specifically designed for use with Sloting Plus wheels. Before installation, check that the 6.0 mm diameter corresponds with your transmission setup. Sloting Plus offers different pulley sizes to adjust the gear ratio according to the circuit and motor used.

Installation and Preparation

Installing the front pulley requires attention to alignment with the rear pulley and the drive belt, if present. A well-fitted mount prevents vibrations and loss of efficiency. The 3D printed structure of this part facilitates a consistent and repeatable fit, which is appreciated when preparation time is tight between heats.

Common Mistakes

• Confusing the diameter: ensure that the size of 6.0 mm fits your transmission system before installation.
• Not checking the alignment: a misaligned pulley causes premature wear of the belt and loss of traction.
• Forcing the fit: the 3D printed mount has tight tolerances; a clean fit without forcing extends the component's lifespan.

Frequently Asked Questions

Which wheels is this pulley compatible with?

It is designed for use with Sloting Plus wheels. Check your wheel reference to confirm compatibility before placing your order.

How many units are included in the pack?

The pack contains 1 unit.

In what type of setup is a front pulley used?

It is used in front transmission or four-wheel drive configurations in slot cars, where the motor's power is also distributed to the front axle via a belt or similar system.

Does the size of the pulley affect the car's behaviour?

Yes. The diameter of the pulley influences the gear ratio: a smaller pulley on the front axle compared to the rear modifies the speed and torque delivered. It is a tuning parameter to consider based on the layout and motor.

Can I replace it without special tools?

In most setups, standard slot preparation tools are sufficient. An axle press or a specific puller can make the job easier if the pulley is pressed onto the axle.

The Sloting Plus Front Pulley 6mm (SRP018121) is a precision slot car spare part featuring a 3D-printed mount, designed for use with Sloting Plus wheels. Essential for front axle transmission setups, this 6.0 mm pulley allows accurate gear ratio tuning for club racing and home track performance. Sold as a single unit.