Nylon Screw M2 16mm (10 units)

T800 16 mm M2 Nylon Screws: Lightweighting Without Compromise in 1/32

When every tenth of a gram counts at the top of the chassis, choosing the right screw makes a real difference. The T800 16 mm M2 Nylon Screws (ref. T839003) are specifically designed for non-critical fixings in 1/32 scale slot cars where reducing mass and lowering the centre of gravity is part of the preparation.

Function and Performance

The technical nylon used in these screws offers more than sufficient mechanical strength to secure bodies, wings, interior supports, and circuit boards. Unlike steel screws, nylon is completely insulating, eliminating any risk of accidental short circuits in areas close to the car's electronics. Its weight is significantly lower than that of metal equivalents, resulting in a direct improvement in cornering behaviour and reduced inertia during direction changes.

Compatibility and Installation

The M2 metric thread is the most widely used standard in 1/32 competition accessories, so these screws fit without adaptations in the vast majority of lexan bodies, wings, and supports on the market. The 16 mm length is intentionally generous: it allows for cutting them with a simple pair of pliers or a cutter to the exact measurement required by each fixing point, preventing the screw head from protruding or the tip from interfering with other internal components.

• M2 metric thread, compatible with most 1/32 competition accessories.
• Length of 16 mm, can be cut to size as needed.
• Material: technical nylon, insulating and ultra-lightweight.
• Pack of 10 units.

Common Mistakes

The most common mistake is attempting to use them in fixing points subjected to intense mechanical stress or extreme continuous vibration without any retaining element (nut or insert). In such cases, it is advisable to combine them with an M2 nylon nut to prevent the screw from loosening with use. Likewise, when cutting the excess length, a clean cut perpendicular to the thread ensures that the nut fits without forcing.

Ideal for…

• Securing lexan bodies without penalising the total weight of the car.
• Mounting wings and aerodynamic appendages in competition preparations.
• Securing interiors, decorative plates, or internal electronic supports.
• Replacing steel screws in high areas of the chassis to lower the centre of gravity.

Frequently Asked Questions

Can I cut these screws without damaging the thread?

Yes. Nylon cuts cleanly with a pair of side-cutting pliers or a cutter. To ensure the nut fits smoothly after cutting, it is advisable to smooth the end with a small file or fine sandpaper to remove any possible burrs.

Are they compatible with standard M2 nylon nuts?

Yes, the M2 metric thread is universal. They work perfectly with any M2 nut, whether nylon or metal, depending on the fixing you need.

Why choose nylon instead of steel for the body?

Nylon weighs considerably less than steel, and since it is located at the top of the car, every gram saved there contributes to lowering the centre of gravity and improving cornering stability. Additionally, being insulating, it eliminates any possibility of accidental electrical contact.

How many screws are included in the pack?

The pack contains 10 nylon screws of 16 mm M2.

Are they suitable for official competition?

It depends on the regulations of each club or championship. The use of nylon instead of metal is usually permitted in most club categories, but we recommend checking the specific regulations before using them in an official event.

T800 M2 nylon screws 16mm (ref. T839003), pack of 10 ultralight non-conductive bolts for 1/32 slot car bodies, wings and lexan interiors. Metric M2 thread, compatible with standard slot car accessories. Cut-to-length design for precise fitment. Ideal for weight reduction and lowering the centre of gravity on competition slot cars.