MAXI spacer 0.10 mm for 1/32 UNIVERSAL guide

A fine adjustment that makes a difference on track

The MAXI SP069003 Spacer from Sloting Plus is a preparation piece designed for those who pay attention to every tenth of a millimetre in the assembly of their guide. With a thickness of 0.10 mm. and MAXI format, it is placed between the screw shaft and the braid support to ensure that the guide works with minimal lateral oscillation.

Function and performance

The function of this spacer is as simple as it is effective: by interposing it at the exact point of attachment of the guide, it reduces unwanted lateral play without stiffening the assembly. The result is a guide that follows the track more faithfully, especially in fast corners and direction changes where any play translates into instability.

The thickness of 0.10 mm. allows for a very precise adjustment. Depending on the tolerance of each chassis or guide, it can be used alone or combined with other spacers of different thicknesses to achieve the exact value you are looking for.

Compatibility

This spacer is of the UNIVERSAL type, which means that Sloting Plus has designed it to fit almost all guides available in the 1/32 market. If the guide accommodates the spacer with minimal lateral play, the assembly is correct. It does not require special tools or additional modifications.

Assembly and preparation

• Place the spacer between the screw shaft of the guide and the braid support.
• Check that it fits with the least lateral oscillation possible: this is the indicator of a correct assembly.
• If the resulting play is still noticeable, combine with spacers of greater or lesser thickness until you achieve the optimal adjustment.
• Review the assembly after the first running sessions, as the settling of the parts may vary slightly.

Common mistakes

• Assembling the spacer without checking lateral play: the goal is not to eliminate all movement of the guide — it needs some freedom to follow the track — but to reduce uncontrolled oscillation.
• Forcing the fit: if the spacer does not fit smoothly, check compatibility with your guide before applying excessive pressure.
• Ignoring wear: like any preparation component, it is advisable to inspect it periodically and replace it if it shows deformation.

Frequently asked questions

What scale is this spacer designed for?

It is designed for 1/32 scale guides, the most common in competitive and recreational slot racing.

Is it really compatible with any guide on the market?

Sloting Plus calls it UNIVERSAL because it adapts to the vast majority of guides available, including those from Scalextric and Ninco, among others. The only condition is that it fits with minimal play between the screw shaft and the braid support.

Can I combine several spacers to increase the total thickness?

Yes. Sloting Plus offers spacers of different thicknesses precisely so you can combine them and achieve the exact adjustment your assembly needs.

When will I notice the difference from using this spacer?

The effect is more evident in sections of fast curves and chicanes where the guide works under lateral stress. Reduced oscillation translates into a cleaner trajectory and fewer disconnections.

Do I need any special tools to install it?

No. The assembly is manual and does not require specific tools beyond the usual screwdriver for the guide screw.

The Sloting Plus SP069003 MAXI spacer (0.10 mm.) is a precision slot car guide spacer for 1/32 scale, designed to minimise lateral play between the guide pin and the braid support. Universal fit compatible with most slot car guides on the market, including Scalextric and Ninco. An essential fine-tuning component for club racers and serious hobbyists looking to improve guide tracking and lap consistency.